Ohio Rapid Fire              

RFAL 7.62 Metric Type III Receiver Assembly

Tools & Materials Needed:

- Parts Kit

- Receiver

- Ejector Block with Pins

- Hammer

- Rubber Mallet

- Punch

- Sharp File

- Good Vise / Holding Fixture

- Cutting Oil

- 1/8 " Drill

- #30 Drill

- 3.5mm Reamer

- #3 Center Drill

(Optional for Chamfer on Ejector Pins)

- Clamp

- 3/32 " Endmill (Optional)

- Dremel Tool, Flap Grinder, or

Wheel Grinder to Dress Pins

Imbel Metric FAL Parts Kit

 RFAL Type III Receiver shown with Ejector Block clamped in place

Receiver clamped in vise tapping Ejector Block into position to check fit

 Ejector Block radius' corners need slight file to enlarge radius

Ejector Block radius again Ejector Block filed and ready
You can increase the receiver radius along with the Ejector Block Another view
Tap Ejector Block in position Another view
Another view Align the Bolt Hold Open and Magazine Catch Screw hole with Ejector Block
Make sure the Ejector Block is flush with the rails Check Magazine for fit
Clamp to hold position (tooling laid out) Starting with the Screw Hole (use the cutting oil)
Install Screw (optional, endmill to align holes for drilling) Drill holes for pins (use cutting oil)
Another view Another view
Optional chamfer to peen pins into Ream holes
Install pins Another view
Another view Pins installed
Peen pins (optional) Another view
Dress pins flush Tools used to install pins
Brownell's Barrel Vise and Receiver Wrench Barrel times at 11 O'clock position
Barrel torqued to 12 O'clock position Close-up of assembled receiver
Imbel Metric FAL kit parkerized and assembled
"If you're a true gunplumber then you should be able to screw one together"
                 
Ohio Rapid Fire RFAL Receiver on G1 Kit Ohio Rapid Fire RFAL Receiver on Imbel Kit